Problem with probe with iosender

[CarloAndrioli]

Hi, i have created a cnc with a T41U5XBB, it works. But now i want to put an YXZ probe, and nothing is going. In iosender, on the probe tab, when i click on the start button, nothings happens and there is a error message in the console view : "error 20 Unsupported or Invalid G-Code Command Found in Block". I spoke with Phil about this, but he don't issue the problem and say that i have to ask you.
my connection is ethernet. I can't do a simple Z probe.
Can you help me ?

[terjeio]

Is the probe pin defined? Check the output from the $pins command in the console, it is near the top of the list.

[CarloAndrioli]

i did it, but now iosender doesn't connect to the T41U5XBB (ethernet connection) and when i connect it in serial, in the console tab i have IP: and there is no adress. But when connect in serial, now the probe is recognized

[CarloAndrioli]

Here are my network parameter

[phil-barrett]

You are set up for DHCP (dynamic) networking. Do you have a router that assigns IP addresses? Is the LED on the MagJack (RJ45) blinking? Is there an LED on your switch/router that indicates the cable is connected to an active networking client?

[CarloAndrioli]

I configured the Fixed PC Ethernet Card 192.168.5.2 and in Iosender, in Setting, Ethernet, we can see the IP address at 192.168.5.1 and the PC is connected directly to the T41U5XBB via an Ethernet cable. I made a ping of my PC around 192.168.5.1, no connection. I changed the cable, I redid a ping, the same thing.

[terjeio]

Change $301 to 0 for static IP. $302 is not used when DHCP is enabled since the IP address then comes from a router which you do not have.

[phil-barrett]

You need to change to IP Mode: Static ($301) [Edit: Terje beat me to it by a minute.]

[CarloAndrioli]

I had changed $301 and i have the connection. and the control for the probe. thanks you two for the help. Now i have to spend my time to put all the setting because i forgot to make a backup. But it's not really a problem. Once more thanks a lot.

[phil-barrett]

Glad you are up and running.